I’ve seen and used the command before, but I’ve never really seen any use of the show ip protocols command until tonight while reading up for my ROUTE test. There’s a lot of good information in the output, and, from the way the book is reading, this is a great candidate for use in a lab question.
To check it out a bit, I set up a small network with four routers connected only to a single Ethernet segment. I set up one router to run EIGRP, OSPF, and BGP to each one of the other routers just so I could see the output for the different routing protocols. Here’s what puked out after struggling with GNS for a few minutes.