I was lucky enough to participate in Tech Field Day 27 a couple weeks months ago. This event brings independent thought leaders together with a number of IT product vendors to share information and opinions. I was not paid to attend, but the organizers did provide travel, room, and meals while I was there. There is no expectation of providing any content, so the fact that I’m mentioning it says something. It was a great event and worth a few hours to check out the videos. Thanks to Gestalt IT for getting me involved.

We’re an Avaya voice shop (for now if I have my way) and have Avaya systems of various sizes and shapes all around the Enterprise.  I was at one of our remote locations a few weeks back and helped the guys there replace a non-PoE switch so they could get the old power injector panel out of their rack.  When we moved stuff around, the phones didn’t come back and had the dreaded DHCP Ack Error.

More study notes.  Correct if wrong, though I hope I get some of it right since I already since I’m an R&S guy.  :$

**Switchport Configuration
**

• switchport mode access:  This config makes the port an access port that carries the primary and voice VLAN traffic
• switchport mode trunk:  This config akes the port a trunk unconditionally, but it will still send DTP messages
• switchport nonegotiate:  This config keeps the port from sending DTP messages.
• switchport mode dynamic auto:  If the port receives DTP messages, it will become a trunk.  If not, it will be an access port.
• switchport mode dynamic desirable:  The port actively sends DTP messages trying to become a trunk.  This is the default configuration on a Cisco switch.

Cisco IP Phone Boot Process

Here’s a handy list of ACL entries to allow your devices to speak routing protocols, availability protocols, and some other stuff. We’ll assume you have ACL 101 applied to your Ethernet inbound; your Ethernet has an IP of 192.168.0.1.

• BGP : Runs on TCP/179 between the neighbors

access-list 101 permit tcp any host 192.168.0.1 eq 179

• EIGRP : Runs on its own protocol number from the source interface IP to the multicast address of 224.0.0.10

access-list 101 permit eigrp any host 224.0.0.10

Let’s keep going with our example setup on the ASA 5505 and set up DHCP on this guy. You can set it up to either forward (relay) DHCP requests to a DHCP server somewhere or have it be the DHCP server. Let’s do it.

To set up DHCP forwarding, you have to configure where the DHCP server is and then enable the relaying on the proper interfaces. Let’s say we have a DHCP server on the inside interface at 192.168.14.11 and we want it to serve IPs to the guests network. Setting up the DHCP server is beyond the scope here, so you’ll have to look elsewhere on how to set that up.