Remember a few weeks back when I had a bad day?  I was actually at HQ that day to do some work for a project, but that got put off due to the extenuating circumstances.  When we finally got back around to do the work, we wound up adding a switch in the data center to extend a VLAN over to a rack.

More study notes.  Correct if wrong, though I hope I get some of it right since I already since I’m an R&S guy.  :$

**Switchport Configuration
**

• switchport mode access:  This config makes the port an access port that carries the primary and voice VLAN traffic
• switchport mode trunk:  This config akes the port a trunk unconditionally, but it will still send DTP messages
• switchport nonegotiate:  This config keeps the port from sending DTP messages.
• switchport mode dynamic auto:  If the port receives DTP messages, it will become a trunk.  If not, it will be an access port.
• switchport mode dynamic desirable:  The port actively sends DTP messages trying to become a trunk.  This is the default configuration on a Cisco switch.

Cisco IP Phone Boot Process